[Numpy-discussion] Installing numpy on py 3.1.2 , osx

Vincent Davis vincent@vincentdavis....
Tue Jun 8 18:04:34 CDT 2010


I do have limits.h in 10.4 sdk

So what next. Ay Ideas?
I had tried to build py 3.1.2 from source but that did not work either.

Thanks
Vincent

On Tue, Jun 8, 2010 at 3:15 PM, Zachary Pincus <zachary.pincus@yale.edu> wrote:
> Hi Vincent,
>
> I'm not really sure -- now the build is using the 10.4 SDK but still
> not finding the right headers.
>
> Could you check to see that the following file exists:
> /Developer/SDKs/MacOSX10.4u.sdk/usr/include/limits.h
>
> If it does, then I'm really not sure what's going on.
>
> Zach
>
>
>
> On Jun 8, 2010, at 3:35 PM, Vincent Davis wrote:
>
>> On Tue, Jun 8, 2010 at 12:26 PM, Zachary Pincus <zachary.pincus@yale.edu
>> > wrote:
>>>
>>>> Failed again, I have attached the output including the execution of
>>>> the above commands.
>>>> Thanks for link to the environment variables, I need to read that.
>>>
>>> In the attached file (and the one from the next email too) I didn't
>>> see the
>>>
>>> MACOSX_DEPLOYMENT_TARGET=10.4
>>> export MACOSX_DEPLOYMENT_TARGET
>>>
>>> lines. Those need to be re-run with each new shell (terminal window)
>>> you start up. (Unless you put them in ~/.profile, etc.)
>>>
>>> You can see from the error messages (after the barf from the 2to3
>>> tool
>>> finishes) that there's still the warning about
>>> MACOSX_DEPLOYMENT_TARGET being set to 10.3.
>>>
>>> If you did in fact run those commands immediately prior to "python3
>>> setup.py build" and still see the MACOSX_DEPLOYMENT_TARGET warning,
>>> then there is definitely some bug in the build process that's
>>> obliterating that environment variable.
>>
>> I did but somehow what was being saved from the terminal was from
>> yesterday ???
>> So to be sure I started over.
>> I have run it again and for sure I have entered the commands, (see
>> attached evidence)
>> MACOSX_DEPLOYMENT_TARGET=10.4
>> export MACOSX_DEPLOYMENT_TARGET
>>
>> I then search the terminal output for "MACOSX_DEPLOYMENT_TARGET" and
>> it only occurred at the beginning where I entered the commands.
>>
>> Thanks
>> Vincent
>>
>>>
>>> Zach
>>> _______________________________________________
>>> NumPy-Discussion mailing list
>>> NumPy-Discussion@scipy.org
>>> http://mail.scipy.org/mailman/listinfo/numpy-discussion
>>>
>> <Terminal Output
>> V3.txt.zip>_______________________________________________
>> NumPy-Discussion mailing list
>> NumPy-Discussion@scipy.org
>> http://mail.scipy.org/mailman/listinfo/numpy-discussion
>
> _______________________________________________
> NumPy-Discussion mailing list
> NumPy-Discussion@scipy.org
> http://mail.scipy.org/mailman/listinfo/numpy-discussion
>


More information about the NumPy-Discussion mailing list